What’s the difference between BSC’s two “burn” addresses — the all-zero address (0x000…0000) and the dead address (0x000…dEaD)?

Question

325 views2025年12月8日

0

Jack 2025年12月8日 0 Comments

On BSC there are two common burn/blackhole addresses: the all-zero address (0x0000…0000) and the dead address (0x0000…dEaD). What’s the difference?

pandatool 更改状态以发布 2025年12月8日

1 Answer

score 0 · Answer 1 · 2025-12-08T10:17:45+00:00

These two addresses are widely used across EVM chains (Ethereum, BSC, Base, Arbitrum, etc.) as burn or blackhole addresses, but they have different origins and practical usage:

All-zero address (0x0000000000000000000000000000000000000000)

This is an Ethereum-protocol-native special address used by the protocol (e.g., for contract creation, default zero values). It’s a technical address.
Historically, some gas-token burns or protocol-level mechanisms reference the zero address.
Some contracts do not accept transfers to the zero address (and the transfer may fail) unless the contract’s code explicitly allows it.

Dead address (0x000000000000000000000000000000000000dEaD)

This is a community-adopted “burn” address — more human-readable and conventionally recognized as “the burn address.”
Many projects prefer sending tokens to the dead address because it’s clearly intended as burnt/irrecoverable.

Are there practical differences if you send tokens to them?

In most cases, sending tokens to either address effectively removes those tokens from circulation (they become irrecoverable to normal users).
Important correction: Sending tokens to the zero address does not automatically change the token contract’s totalSupply unless the token’s contract explicitly implements a burn function that deducts from totalSupply. Standard ERC-20 transfers simply transfer balance from A to B; if B is the zero address the tokens sit in that address and the on-chain totalSupply value remains the same unless the contract decreases it in a burn operation. The same applies to the dead address — tokens sitting in the dead address are inaccessible but totalSupply only changes if the contract’s burn logic updates it.
Because of contract differences, some contracts block transfers to 0x000…0000 (so the tx would fail); sending to 0x…dEaD is often more compatible and visually obvious to the community.

PandaTool’s recommendation

For burning tokens, use the dead address (0x…dEaD) in most cases because it’s more standard and less likely to hit contract restrictions.